New C Rotor with free flooting C

[MaRiJonas]

Hello Bob,

great work you´ve done!!! I´m very impressed of the smart controller, you´ve developed. Congratulations.

But I don´t know, if I understood you right in the video. You´ve generated 40 watts 9 times?!

Kind regards,

Richard

[BobMann]

Hello Bob,

great work you´ve done!!! I´m very impressed of the smart controller, you´ve developed. Congratulations.

But I don´t know, if I understood you right in the video. You´ve generated 40 watts 9 times?!

Kind regards,

Richard

Thank you for the kind words.
The doll house is 9 LED that use 9 watts each replaces a 40 watt old kind of bulb. so it was about 80+ watts right out of the Mann Smart Drive.
For the grid tie test the most I could push out by hand in to the wall outlet was 35 watts With out the Smart Controller
Using the Smart Controller I can push in the wall outlet 90+ with the same fource
This is were the Smart Controller shines it lets you pull all the power that gets stuck in the stator and makes it useable.
Bob Mann

[MaRiJonas]

Hello Bob,

thank you very much for your explanation. I coudn´t believe, that you can push 360 watts with a smiling on your face .

Yes, I saw your video competition against the Grid . Are the Generator and Smart Controler ready for series?

What would they cost, and where would we be able to buy?

What output voltage has the Smart-Controller? Certainly specified for US-Market.

Kind regards

Richard

[BobMann]

hello the Smart Drive is on Ebay right now and my C Floating blade turbine too.
The Smart controller is ready we program it for 50 volt DC out put ( we cam program for any voltage that is needed) so you can just hook up to the cheap grid ties.
We are looking at a price point of $400 US.
Bob Mann
bobtec@comcast.net